Deleting Users; Block Delete Users - HID ENTRYPROX User Manual

7.8 Deleting Users

To delete a user from the EntryProx, you must know the User Location in which the information is
stored.
1. Place the EntryProx unit in program mode.
Press: 99 # Master Code *
2. On the EntryProx keypad,
Press: user location #**
3. Press * to exit program mode.

7.9 Block Delete Users

Use Command 58 to delete all cards/PINs in a block of User Locations. The yellow LED will blink
rapidly during the deletion process. It can take several seconds to delete large blocks of users.
Note: Entering a starting user location or number of locations which exceeds 2000 will generate a
programming error.
To block delete user locations, follow this procedure:
1. Place the EntryProx unit in program mode.
Press: 99 # Master Code *
2. On the EntryProx keypad.
Press: 8 # start location # start location # number of locations * number of locations*
3. Press * to exit program mode.
Page 28 of 38
EntryProx User Manual, 4045-905, Rev. C.4
September 2016