Motor Controller; Troubleshooting - Taylor-Dunn B0-248-36 Service Replacement Parts

B0-248; B0-254; BT-248; BT-280 (36v & 48v)
REPAIR/PROGRAMMING
NOTICE
The controller power base and logic are a
matched set. DO NOT swap logics from one
base to another as this may damage the logic
or power base.
Repairs
There are no internally serviceable components in the
motor speed controllers. If a controller is faulty then it
must be replaced.
Note: Opening or disassembling a controller will
void the controller warranty.
Programming
Taylor-Dunn does not support field modifications to the
controller parameters.
Complete vehicle parameters are available by e-mail
and can be uploaded to the controller using a laptop or
PC with the PCpaK application and cable. Refer to the
Tools section for part numbers.
If you have a special application that may require modified
parameters, contact your local authorized Taylor-Dunn
distributor to submit a request to the factory. Note: There
may be a fee to created a custom parameter set.
Instructions for obtaining parameter sets and how to
upload to the controller are included with the application.
MB-248-18

Motor Controller

TROUBLESHOOTING

Troubleshooting control system is not included in this
manual.
All electrical troubleshooting information is included in
a separate manual "Troubleshooting Electric Vehicles".
part number M7-001-69.
This manual was provided on the original vehicle CD.
A hard copy can be purchased from your authorized
Taylor-Dunn distributor or can be downloaded from the
Taylor-Dunn web site.
HARDWARE TORQUE
If hardware is not listed here, refer to standard torque
values in the appendix.
Description
Terminal stud
Inch Pounds Newton Meters
38-44 4.29-4.97
Page 69