Replace Steering Wheel - Taylor-Dunn B0-248-36 Service Replacement Parts

Steering

REPLACE STEERING WHEEL

WARNING
This section is one section of a complete service
manual. Before starting any procedure, read all
warnings and instructions that are located in the
Service Guidelines chapter.
Note: The steering wheel is on a tapered shaft and may be damaged when it is removed.
1: If equipped with a horn switch in the steering wheel,
remove the switch and disconnect the wires from the
switch.
2: Remove the steering wheel nut.
3: Using a steering wheel puller, remove the steering wheel.
4: Position the front wheels in the straight ahead position.
5: Lightly grease the steering wheel splines and install the
replacement steering wheel orientated as shown in the
illustration.
6: Tighten the steering wheel nut to torque listed in the
Hardware Torque table at the end of this section.
7: Reinstall the horn switch (if equipped).
8: Reconnect the main positive and negative cables at the
batteries.
9: Remove the blocks from behind the wheels.
10: Release the parking brake and test drive.
Page 48
B0-248; B0-254; BT-248; BT-280 (36v & 48v)
MB-248-18