Creating A Traffic Policy - Huawei S3700HI Configuration Manual - Qos

S3700HI Ethernet Switches
Configuration Guide - QoS
l When the burst size of a packet is smaller than the CBS value, the packet is colored green.
l When the burst size of a packet is equal to or larger than the CBS value but smaller than the
l When the burst size of a packet is equal to or larger than the PBS value, the packet is colored
Step 4 Run:
quit
Exit from the traffic behavior view.
Step 5 (Optional) Conduct the following steps to configure aggregate CAR.
1.
2.
3.
4.
----End

2.3.4 Creating a Traffic Policy

You can associate a traffic classifier with a traffic behavior in a traffic policy.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
traffic policy policy-name [ match-order { auto | config } ]
Issue 01 (2012-03-15)
PBS value, the packet is colored yellow.
red.
Run:
system-view
The system view is displayed.
Run:
qos car car-name cir cir-value [ cbs cbs-value [ pbs pbs-value ] | pir pir-
value [ cbs cbs-value pbs pbs-value ] ]
A CAR profile is created.
NOTE
Aggregate CAR supports only the single token bucket.
Run:
traffic behavior behavior-name
A traffic behavior is created and the traffic behavior view is displayed.
Run:
car car-name share
An aggregate CAR action is configured.
NOTE
Aggregate CAR is valid for only incoming packets.
After aggregate CAR is configured, the rules in a traffic classifier bound to a traffic behavior share
a CAR index. The system aggregates the traffic and implements the CAR for the traffic. If the traffic
classifier contains both Layer 2 information-based rules and Layer 3 information-based rules, the
car share command does not take effect.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2 Traffic Policing and Traffic Shaping Configuration
60