Table of Contents
Advertisement
S3700HI Ethernet Switches
Configuration Guide - QoS
Issue 01 (2012-03-15)
NOTE
The mac-acl-number parameter specifies the number of a Layer 2 ACL. The value is an integer
that ranges from 4000 to 4999.
3.
(Optional) Run:
step step-value
The step value between ACL rule IDs is set.
4.
Run the following commands as required.
– When the parameter protocol is specified as the Internet Control Message Protocol
(ICMP), the command format is as follows:
– rule [ rule-id ] { deny | permit } { protocol-number | icmp } [ destination
{ destination-address destination-wildcard | any } | dscp dscp | fragment |
logging | icmp-type { icmp-name | icmp-type icmp-code } | precedence
precedence | source { source-address source-wildcard | any } | time-range
time-name | tos tos | ttl-expired ]
– When the parameter protocol is specified as the Transmission Control Protocol
(TCP), the command format is as follows:
– rule [ rule-id ] { deny | permit } { protocol-number | tcp } [ destination
{ destination-address destination-wildcard | any } | destination-port { eq |
gt | lt | range } port | dscp dscp | fragment | logging | precedence
precedence | source { source-address source-wildcard | any } | source-port
{ eq | gt | lt | range } port | tcp-flag { ack | fin | psh | rst | syn | urg }
range time-name | tos tos | ttl-expired ]
– When the parameter protocol is specified as the User Datagram Protocol (UDP),
the command format is as follows:
– rule [ rule-id ] { deny | permit } { protocol-number | udp } [ destination
{ destination-address destination-wildcard | any } | destination-port { eq |
gt | lt | range } port | dscp dscp | fragment | logging | precedence
precedence | source { source-address source-wildcard | any } | source-port
{ eq | gt | lt | range } port | time-range time-name | tos tos | ttl-expired ]
– When the parameter protocol is specified as another protocol rather than TCP,
UDP, or ICMP, the command format is as follows:
– rule [ rule-id ] { deny | permit } { protocol-number | gre | igmp | ip | ipinip |
ospf } [ destination { destination-address destination-wildcard | any } |
dscp dscp | fragment | logging | precedence precedence | source { source-
address source-wildcard | any } | time-range time-name | tos tos | ttl-
*
expired ]
– When protocol is set to TCP, the command format of an advanced ACL6 rule is
as follows:
rule [ rule-id ] { deny | permit } { tcp | protocol-number } [ destination
{ destination-ipv6-address prefix-length | destination-ipv6-address/prefix-length
| postfix postfix-length | any } | destination-port { eq | gt | lt | range } port |
dscp dscp | fragment | logging | precedence precedence | source { source-ipv6-
address prefix-length | source-ipv6-address/prefix-length | source-ipv6-address
postfix postfix-length | any } | source-port { eq | gt | lt | range } port | tcp-flag
{ ack | fin | psh | rst | syn | urg }
– When protocol is set to UDP, the command format of an advanced ACL6 rule is
as follows:
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1 Class-based QoS Configuration
*
*
*
| time-rangetime-name | tos tos ]
*
| time-
*
*
15
Advertisement
Table of Contents
