Checking The Configuration; Maintaining Traffic Policing And Traffic Shaping - Huawei S3700HI Configuration Manual - Qos

S3700HI Ethernet Switches
Configuration Guide - QoS
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The interface view is displayed.
Or, run:
port-group port-group-name
The port group view is displayed.
Step 3 Run:
qos queue queue-index shaping cir cir-value pir pir-value [ cbs cbs-value pbs pbs-
value ]
The rate for traffic shaping in an interface queue is set.
By default, the rate for traffic shaping in an interface queue is the maximum bandwidth of the
interface.
----End

2.4.5 Checking the Configuration

After traffic shaping is configured, you can view the rate limit on an interface or in an interface
queue.
Context
Before viewing the traffic shaping parameters of an interface queue, run the qos queue statistics
enable command to enable the traffic statistics function for the interface queue.
Procedure
l
l
l
----End

2.5 Maintaining Traffic Policing and Traffic Shaping

This section describes how to maintain traffic policing and traffic shaping.
Issue 01 (2012-03-15)
NOTE
Create a port group before performing this task. For details on how to create a port group, see Configuring
the Interface Group in the S3700HI Ethernet Switches Configuration Guide - Ethernet.
Run the display qos lr { inbound | outbound } interface interface-type interface-
number command to check the rate limit on the specified interface.
Run the display qos queue statistics interface interface-type interface-number command
to check the rate limit of the interface queue.
Run the display qos configuration interface interface-type interface-number command
to check all the QoS configurations on the interface.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2 Traffic Policing and Traffic Shaping Configuration
66