Wireless Connection Troubleshooting - Technicolor TG588v v2 Setup And User Manual

6.3 Wireless connection troubleshooting

Cannot connect via WPS
If you have trouble connecting your wireless client via WPS, try one of the following:
• The WPS session only lasts 2 minutes, make sure to press the WPS button on both devices within this time slot.
• Wait until the WPS LEDs of the TG588v v2 and other devices are off and then try again.
• Move the devices closer to each other.
• Make sure that the wireless inteface and WPS are enabled on the TG588v v2. Proceed as follows:
a Browse to the
For more information, see
b Click Wireless. The Wireless page appears.
c In the Wireless card header, make sure that the switch is
d In the upper-right corner, click show advanced.
e Under Access Point, make sure that:
• Broadcast SSID is switched to
• WPS is switched to
• Security mode is not WEP.
f If you made changes, click Save.
If the problem persists, configure your wireless client manually. For more information, see
wireless client" on page
Forgot your wireless key?
If you have changed the wireless settings manually and you don't remember your settings, try one of the following:
1 Use a computer that is already connected to your network.
If none of your computers is connected to the wireless network, connect one with an Ethernet cable. For more
information, see
2 Browse to the web interface.
For more information, see
3 Click Wireless. The Wireless page appears.
4 Under Access Point, you can find the network name (SSID) and wireless key (password).
DMS3-CTC-25-42 v1.0
TG588v v2 web interface.
"4.1.1 Accessing the TG588v v2 web interface from your local network" on page
.
.
22.
"2.4 Connecting your wired devices" on page
"4.1.1 Accessing the TG588v v2 web interface from your local network" on page
.
"3.2 How to manually connect a
15.
6 Support
29.
29.
53