Chapter 1: Connections And Setup; Turning On The Wireless Voice Gateway; Introduction; Wireless Voice Gateway Features - Technicolor TC7200.20 User Manual

CHAPTER 1: CONNECTIONS AND SETUP

Turning on the Wireless Voice Gateway

After installing the Wireless Voice Gateway and turn it on for the first time (and each time the modem is
reconnected to the power), it goes through several steps before it can be used. Each of these steps is
represented by a different pattern of flashing lights on the front of the modem.
If there is no lighted LEDs on the front panel, check the power adapter plug-in the power jack and connect to
CM correctly.
Note: All indicators flash once before the initialization sequence.
If both DS and US LEDs are flashing, it means the Wireless Voice Gateway is automatically updating its
system software. Please wait for the lights to stop flashing. Do not remove the power supply or reset the
Wireless Voice Gateway during this process.

Introduction

Wireless Voice Gateway Features

Full Band Capture Front End

Increases performance with 50% increase in CPU speed.

Adds Applications CPU to run Linux applications.

Enables concurrent dual band Wi-Fi with 1 PCIe.

Lowers Power with Advanced Power Management

Advanced Processor architecture.

High-Speed Memory architecture.

Integrated IPTV solution.

Excentis Euro-DOCSIS 1.0/1.1/2.0/3.0 Standard Compliant.

Euro-PacketCable 1.0/1.5 Standard Compliant

Support Multiple Provisioning mode.

Standard RJ-45 connector for 10/100/1000BaseT Ethernet with auto-negotiation and MDIX functions;

Support maximum Ethernet cable length up to 100m (Category 5).
RJ-11 Foreign Exchange Station (FXS) port for IP telephony; Support a maximum line length between

themselves and an end-receiver (handset, etc.) of up to 500 feet (AWG 26/0.4mm).
Support simultaneous voice and data communications.

One voice conversations in the FXS port with different CODEC:

G.711‐ ulaw, G.711‐ alaw, G.723.1, BV16, ILBC, G.726‐ 16, G.726‐ 24, G.726‐ 32, G.726‐ 40,
G.728, G.729, G.729E, G.729A, G.729B, TELEVENT, T.38
Default codecs: G.711‐ ulaw, G.711‐ alaw, BV16, ILBC, TELEVENT, T.38

Echo Cancellation.

Voice Active Detection (VAD).

DTMF detection and generation.

Comfort Noise Generation (CNG).

Support V.90 fax and modem services.

56 bits DES and 128 bits AES data encryption security.

SNMP network management support.

802.11a/b/g/n supported, 20/40 MHz bandwidth, 300Mbps Maximum data rate.

BCM43228 support both 2.4 GHz and 5 GHz.

Support Web pages and private DHCP server for status monitoring.

The NTP (Network Termination Point) should be able to operate with an LF (Loading Factors) of at

least 100 LU.
Page 7 / 85