Configuring Radius Accounting Servers And Related Parameters - H3C S3610 Series Operation Manual

Operation Manual – AAA & RADIUS & HWTACACS
H3C S3610&S5510 Series Ethernet Switches

1.4.3 Configuring RADIUS Accounting Servers and Related Parameters

Table 1-14 Configure RADIUS accounting server and related parameters
Operation
Enter system view
Create a RADIUS
scheme and enter
its view
Set the IP address
and port number of
the
RADIUS
accounting server
Set the IP address
and port number of
the
RADIUS
accounting server
Enable
stop-accounting
packet buffering
Set the maximum
number
stop-accounting
request
allowed
Set the maximum
number
real-time
accounting request
attempts
Command
system-view
radius
radius-scheme-name
primary
primary ip-address
[ port-number ]
secondary accounting
secondary ip-address
[ port-number ]
stop-accounting-buffer
enable
of
retry stop-accounting
retry-times
failures
of retry
realtime-accounting
retry-times
Chapter 1 AAA & RADIUS & HWTACAC
—
Required
scheme
By default, a RADIUS scheme
named "system" has already
been created in the system.
Required
accounting
By default, the IP address and
UDP port number of the primary
accounting server are 0.0.0.0 and
1813.
Optional
By default, the IP address and
UDP
secondary accounting server are
0.0.0.0 and 1813.
Optional
By
packet buffering is enabled.
Optional
By
stop-accounting request failures
are allowed.
Optional
By default, the maximum number
of real-time accounting request
attempts is 5. After that, the user
connection is cut down.
1-27
S Configuration
Description
port number of
default, stop-accounting
default, up to
the
500