Setting - Eiki EK-510U Owner's Manual

Setting

Your projector comes with convenient adjustment function.
1 Press the MENU button on remote controller and the OSD displays. Press
Setting icon, press
2 Press button to point to required item and press OK button to confirm your selection.
On start
Setting the projector to be turned on automatically
just by connecting the AC power cord.
On .......... Start the projection immediately,
enter countdown display.
Off .......... Start up in the standby mode.
Standby mode
Press button to select the item below:
Eco.......... Restrict some functions in the
standby mode to reduce power
consumption. In this case, you
cannot use network functions and
some RS-232C commands.
Normal ... Do not restrict network function
and serial communication function
even in the standby mode.
High land
Control the fan through the Setting menu.
Off ...... Normal speed. Set it so if the projector is operated at a lower altitude.
On ...... Faster than Off. Set it so if the projector is operated at a higher altitude.
Note:
● When operating the projector at an altitude around 1400~2700m, please setting as ON.
● When you select High land "On" , brightness is change to Eco automatically. When you restore the
High land to Normal, please select Normal or Eco again in lamp control setting of OSD.
Lamp control
Change the brightness of the screen.
Normal .... Normal brightness.
Eco .......... Lower brightness, reducing power consumption and extending the lamp life.
Cooling fast
provides the following options in the cooling fans' operation after turning off the projector.
Normal .. As default cooling time.
60 sec ... Faster cooling time and louder noise
of fan.
Closed caption (Video signal only)
Allows the subtitle to be displayed for the
audio contents or other information. If the
input source contains closed caption, you can
OSD setting-Setting
button or OK button to confirm your selection.
Setting
On start
Standby mode
High land
Lamp control
Cooling fast
Closed caption
Key lock
Iris
Remote control
Sound
HDMI Setup
Setting
On start
Standby mode
High land
Lamp control
Cooling fast
Closed caption
Key lock
Iris
Remote control
Sound
HDMI Setup
button to select
Off
Eco
Off
Normal
Off
On
Off
Eco
Off
Normal
Off
On
43