Osd Setting-Setting; Direct Power On; Standby Mode; High Land Function - Eiki EK-361WST Owner's Manual

Setting
Your projector comes with convenient adjustment function.
1 Press the MENU button on remote controller and the OSD displays. Press
Setting icon, press
button to point to required item and press OK button to confirm your selection.
2 Press

Direct power on

Setting the projector to be turned on automatically
just by connecting the AC power cord.
On ... Start the projection immediately.
Off ....Start up in the standby mode.

Standby mode

Setting the power consumption in standby mode.
Eco......... Restrict control functions in the standby
mode to reduce power consumption. In this
case, you could control the projector with
limited.
Network.. Restrict network and serial communication
function to reduce power consumption.
Normal ... Do not restrict network function and serial communication function even in the standby mode.
LAN RS232C Keypad IR Control
х
ECO
х
Network
√
Normal
х: No Control Δ: Power On command Only
▲: Power On command and Wake on LAN
√: All commands are active
High land
Control the fan speed while cooling according the operating condition.
Off ... Normal speed. Set it so if the projector is operated at a lower altitude.
On ... Faster than Off. Set it so if the projector is operated at a higher altitude.
Note:
● When operating the projector at an altitude around 1400~2700m, please setting as ON.
Cooling fast
provides the following options in the cooling fans' operation after turning off the projector.
Normal .. As default cooling time.
38

OSD setting-Setting

button or OK button to confirm your selection.
Δ Δ
▲ Δ
√ Δ
Setting
Direct power on
Standby mode
High land
Cooling fast
Key lock
Contrast optimization
Laser control
Sound
HDMI Setup
Δ
Δ
Δ
button to select
Off
Eco
Off
0 sec
Off