Power Off Your Projector - Eiki EK-510U Owner's Manual

Table of Contents

Advertisement

Power off your projector

1. Press the Power button at the rear control
panel or the remote controller, the "Power
off?" message displays.
2. Press the Power button again in 4 seconds
after the "Power off?" message prompted
to you. The POWER indicator flashes red
while the cooling fan continues running.
(You may set up noise level and speed of
the fan.) Unplug the power cord until the fan
stops running. Failure to do so may shorten
life cycle of your projector or lead to power
on failures or operation abnormalities.
3. The POWER indicator stops flashing once
the projector has been cooled down to
ready for power on again.
To maintain the life cycle of the lamp,
power off your projector after it has
been turn on for at least five minutes.
Do not use your projector without
stop. As it may hurt the life cycle of
your lamp. Power off your projector at
least once every 24 hours and have
it idle for an hour.
Note:
● If the "On Start" function is set to "On", your projector will power on once it is connected to an
AC power socket. (Refer to page 43)
● Speed of the cooling fan varies with internal temperature of your projector.
● Do not place your projector in any box before it is fully cooled down.
● In case the POWER indicator flashes or turns red, refer to the "Light indicator status" for
instructions. (Refer to page 77)
● The POWER indicator flashes when the lamp is cooling down. Do not power on your projector
at this time. Power on your projector only after the POWER indicator turns red.
● Unplug the power cord after your projector has been turned off. The fan stops running.
● The POWER indicator turns red when your projector is ready for power on again. It takes less
time to restart your projector after it was powered off in the standard power off procedure than
that of the non-standard one.
Basic operation
VOL-
VOL+
Power off?
"Power off?" message disappears
in 4 seconds.
VGA
Power
IN
P/PR
G/Y
MONITOR OUT
VIDEO
S-VIDEO
AUDIO
AUDIO
AUDIO
RS-232C
IN1
OUT
IN2
360.2
Power
29
B/PB
H/H

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ek-510ulEk-511wEk-511wlEk-512xEk-512xlEk-510 series

Table of Contents