Basic Operation; Power On Your Projector - Eiki EK-510U Owner's Manual

Power on your projector

1. Connect all external equipment to your projector (e.g. computer or camera) before powering it
on.
2. Connect AC power cord of your projector to an AC power socket. The Power indicator turns on
in red.
3. Press the Power button on the rear control panel or the remote controller.
The Power indicator lights in green and the cooling fan starts running.
4. If your projector is setting as password protected, the password dialog box displays. Enter your
password as instructed below.
Enter password (PIN)
Press ENTER button to start input the PIN code. Press
ENTER button to select and the cursor would move to next field automatically. The number you typed
is displayed as " ". Repeat this step to fill in a 3-digit number. If any mistake, press MENU button to
reset.
After fill in the PIN code, the cursor would
move to the "Set" selection. Press the ENTER
button and now you are ready to use your
projector. Or press
give up the setting.
If the password is invalid, the password dis-
played as " " will be in red. Please try again
with a valid one.
What is a password (PIN)?
A password (PIN) is an ID code for identifying people with knowledge about it to oper-
ate your projector. A password (PIN) setting may help preventing your projector from
unauthorized use.
You password (PIN) code is a 3-digit number. To find out more about protecting your
projector with a password (PIN), please refer to the PIN Code Lock function in the
Setup menu on Page 49 for details.
Precautions on password (PIN) operation
You cannot operate a password (PIN) protected projector without correct password
(PIN) Please set up a new password (PIN) and keep your operation manual in safe
place. In case the password (PIN) is lost or forgotten, call your dealer or service center.
28

Basic operation

button select "Cancel" to
VIDEO S-VIDEO
VOL- VOL+
button to select a number, then press
Note:
● In case the "Logo Select" option is set
to OFF, then no welcome image will
display in screen.
● You can do nothing but powering off
your projector during the welcome
image is displaying.
VGA
Power
IN
P/PR G/Y B/PB H/HV
MONITOR OUT
AUDIO AUDIO AUDIO RS-232C R/C
IN1 OUT IN2 IN
360.2
DVI-D
V
R/C AUDIO
OUT
Power