MAC TOOLS MDT 10 Operator's Manual page 90

Location
Used to find where specific components are located.
1. Select Location Info from the Diagnostic Information screen.
2. Scroll through the list and select the desired component.
Brake Bleed Procedure (ABS)
Provides the procedure on how to bleed the brakes after replacing brake calipers or opening a brake line to
atmosphere.
1. Select Brake Bleed Procedure from the Diagnostic Information screen.
2. It may be necessary to change controllers at the Home Screen, then re-enter diagnostic information for this
selection to become available (ABS, ABS/VSES).
NOTE: The sequence may be contained within the previous brake bleed procedure section if it is not separately
listed on the Diagnostic Information screen.
90
ss02517
Current
Location
2004
FUSE BOX LOCATION
Ford
ECU LOCATION
DLC LOCATION
COMPONENT LOCATION
ss02518
Current
Brake Bleed Procedure
2004
ABS Bleed Procedures
Ford
Brake Bleed Sequence: N/A
GRAVITY BLEED
1) Warning: brake fluid contains polyglycol ethers and polyglycols. Avoid contact with eyes. Wash hands throughly after
handling. If brake fluid contact eyes, flush eyes with running water for 15 minutes.
2) Get medical attention if irritation persists. If taken internally, drink water and induce vomiting. Get medical attention
immediately. failure to follow these instructions may result in personal injury.
3) CAUTION: Do not allow the brake master cylinder reservoir to run dry during the bleeding operation. Keep the brake master
cylinder reservoir filled with the specified brake fluid. Never reuse the brake fluid that has been drained from the hydraulic
system
4) CAUTION: Do not spill brake fluid onto painted or plastic surfaces. If spilled, wipe away immediately before damage to the
plastic or painted surfaces occurs.
5) NOTE: When any part of the hydraulic system has been disconnected for repair or new installation, air may get into the
system and cause spongy brake pedal action.
Battery junction box is located in the left rear engine compartment. The central junction box
is located under the dash panel, near the steering column.
MACTOOLS.COM