MAC TOOLS MDT 10 Operator's Manual page 64

Manual DTCs
Certain vehicles do not support standard DTC protocol and will require a manual process for retrieving and
clearing codes.
1. Follow the prompts on the screen for retreiving DTCs.
2. Select Diagnostic Trouble Codes button.
3. Follow the prompts on the screen.
64
ss02469
Current
Diagnostic Trouble Codes
CHECK
2002
Subrau
1) Take out diagnosis connector from side of drive's seat heater unit.
2) Turn ignition switch Off.
3) Connect diagnosis connector terminal 6 to diagnosis terminal.
4) Turn ignition switch On.
5) ABS warning light is set in the diagnostic mode and blinks to identify trouble code.
6) After the start code (11) is shown, the diagnostic trouble codes (DTC) will be shown in order of
ss02470
Current
Diagnostic Trouble Codes
CHECK
2002
Subrau
1) Take out diagnosis connector from side of drive's seat heater unit.
2) Turn ignition switch Off.
3) Connect diagnosis connector terminal 6 to diagnosis terminal.
4) Turn ignition switch On.
5) ABS warning light is set in the diagnostic mode and blinks to identify trouble code.
6) After the start code (11) is shown, the diagnostic trouble codes (DTC) will be shown in order of
ss02471
Current
Diagnostic Trouble Codes
Diagnostic Trouble Codes
CHECK
2002
11
Subrau
1) Take out diagnosis connector from side of drive's seat heater unit.
21
2) Turn ignition switch Off.
3) Connect diagnosis connector terminal 6 to diagnosis terminal. 22
4) Turn ignition switch On.
23
5) ABS warning light is set in the diagnostic mode and blinks to identify trouble code.
24
6) After the start code (11) is shown, the diagnostic trouble codes (DTC) will be shown in order of the last information first.
These repeat for a maximum
7) NOTE: When there are no
25
8) When on-board diagnosis
stored in the EEPROM as a
(Stored codes will stay in me
Start Code: Trouble Code Is Shown
After Start Code Only Start Code Is
Shown In Normal Condition
Abnormal ABS Sensor (Open Circuit
Or Input Voltage Too High) - Front
Right ABS Sensor
Abnormal ABS Sensor (Abnormal
ABS Sensor Signal) - Front Right ABS
Sensor
Abnormal ABS Sensor (Open Circuit
Or Input Voltage Too High) - Front
Left ABS Sensor
Abnormal ABS Sensor (Abnormal
ABS Sensor Signal) - Front Left ABS
Sensor
de (11) is shown.
Abnormal ABS Sensor (Open Circuit
Or Input Voltage Too High) - Rear
Right ABS Sensor
n (up to a maximum of three) will be
e, the most recent three will be stored.
Close
MACTOOLS.COM