MAC TOOLS MDT 10 Operator's Manual page 69

4. Select the Volkswagen/Audi Group. When finished go to Step 6.
5. Follow the prompts on the screen. Select or Customize a group.
Data Groups
• Data groups may be selected at any time within data stream.
• Select the data group menu button from the top of the screen.
• Scroll through the menu until the desired data group is found, then select it.
Note: It is possible to change controllers while in data stream.
• Select the controller selection button.
• Select the desired controller.
• Once controller is selected, select the data group menu button.
• Select the desired data group.
800.MACTOOLS
ss02478
Current
1001
101001 Data Stream
0101
2003
All Data Groups
Cadillac Volkswagen/Audi Group
System Status
Volkswagen/Audi Group
Enter a Group Between: 0 and 255
System Status
Ignition
System Status
Knock Control
Ignition
-
+ .
*
,
/
( )
=
ss02479
Current
1001
101001 Data Stream
0101
2003
All Data Groups All Data Groups
Cadillac
Search all Data Streams
All Data Items
All Data Items
EVAP Data
* Clutch Start Switch (If Equipped)
Engine Data 1 * PNP Switch (If Equipped)
A/C High Side Pressure Sensor
A/C Pressure Disable
Engine Data 2
A/C Relay Command
Acceleration Pedal Position At Idle
Accelerator Pedal Position Sensor 1 Voltage
Engine Data 3
EVAP Data
Fuel Trim Data
Accelerator Pedal Position Angle
Calculated BARO
Misfire Data
Engine Coolant Temperature
Engine Speed
TAC Data
Evaporative Emissions Vent Solenoid
Fuel Level Sensor Left Tank
Fuel Tank Pressure
Engine Data 1
Cancel OK
1 2
4 5
7 8
*
0
* Cruise Clutch Switch (If Equipped)
A/C High Side Pressure
A/C Off For Wide Open Throttle
A/C Relay
A/C Request
Accelerator Pedal Position Angle
Accelerator Pedal Position Sensor 2 Voltage
Battery Voltage
Desired Idle Speed
Engine Run Time
Evaporative Emissions Canister Purge
Fuel Level
Fuel Level Sensor Right Tank
Fuel Tank Pressure Sensor
Select Customize
Select Customize
Select Customize
3
6
9
#
Select Customize
Select Customize
Select Customize
69