Cable Connection - MAC TOOLS MDT 10 Operator's Manual

Restarting the tool:
1. Press and release the power button.
2. Select OK. The tool will now shutdown and restart automatically.
When switching vehicles, it is best to return to the home screen before disconnecting the VCI from the vehicle
to avoid communication errors.
Automatic Pairing
Automatic pairing will reconnect the last paired VCI to the handset during the start up process, as well as after
unplugging and plugging the VCI back into an OBDII/DLC connector.
NOTE: After booting the handset, automatic pairing works immediately and ready when tool is booted. If it does
not pair within a minute, repeat the manual VCI pairing procedure for that VCI. Typical connection time after
Connect to VCI message is displayed is 5-15 seconds. If this happens, reboot the handset and allow it to auto-
pair. If it still fails to auto-pair then repeat the manual VCI pairing procedure.
VCI connection status icon will typically take 10-20 seconds to update after pairing the VCI to the handset.
When connection is lost, the VCI connection status Icon will typically take 10-20 seconds to update.

Cable connection

Connect the VCI OBDII/DLC cable into the vehicle. Using the Using the VCI Communication cable provided in
the kit, plug the appropriate end (B) of the cable into the VCI, then the opposite end into a USB VCI port on the
handset. VCI Connection Manger will switch icons to the USB icon.
22
ss02585
ss02403
Active
Search Google for ...
CHECK
Read DTCs
Power off
Diagnostic Tool will shut down.
Maintenance Tests
No Vehicle Selected
CHECK
Automated System
OBD-II
Tue, 10 May 2016
Select Vehicle
1001
101001
0101
Data Stream Special Tests
All System DTC
Scan Browser
CANCEL
View Data Stream
Test Veiw Saved Tests Recordings
2:59
Diagnostic
Information
Settings
OK
System Wiring
Diagrams
MACTOOLS.COM