MAC TOOLS MDT 10 Operator's Manual page 61

Read DTCs Button Definitions
Ford/Lincoln/Mercury
Self Diagnostics button displays a pop up menu
allowing the user to choose between specific
special tests.
GM/GMC
Status button displays a pop up menu allowing
the user to view the status on DTCs
Clear DTCs Button
The Clear DTCs button is used to clear codes
and remove all but permanent DTCs on the
selected controller. To clear codes, complete the
following:
NOTE:
Clearing DTCs will erase current Mode 1 Readi-
ness monitor information and require the user
go through necessary drive cycles over again. So,
if Mode 1 information needs to be reviewed, be
sure to view it before clearing codes.
If a code will not clear, turn the ignition o for at
least 10 seconds; turn it back on to KOEO, then
retry. Some controllers will go to sleep after a
period of inactivity and prevent clearing DTCs.
This key cycle may be needed when attempting
to communicate with other controllers after a
period of time on a different controller.
Refresh DTCs Button
Tapping the Refresh button initiates a fresh scan
of DTCs from the vehicle.
Share DTCs Button
Tapping the Share button opens the app and
initiates one of two options, share by email or
Bluetooth email concontaining a list of all the
DTCs set.
Menu Button
Tapping the Menu button displays a pop-up link
that takes the user to help content related to
reading DTCs.
Note: an active internet connection will be
required.
View Help
Selecting View Help will open an online opera-
tors manual.
Take Screen Capture
Selecting Take Screen Capture will save a copy
of the current open screen.
800.MACTOOLS
61