MAC TOOLS MDT 10 Operator's Manual page 37

DTCs Modes 3, 4, 5, A Button Definitions
Clear DTCs Button
The Clear DTCs button is used to clear codes
and remove all but permanent DTCs on the
selected controller. To clear codes, complete the
following:
NOTE:
Clearing DTCs will erase current Mode 1 Readi-
ness monitor information and require the user
go through necessary drive cycles over again. So,
if Mode 1 information needs to be reviewed, be
sure to view it before clearing codes.
If a code will not clear, turn the ignition o for at
least 10 seconds; turn it back on to KOEO, then
retry. Some controllers will go to sleep after a
period of inactivity and prevent clearing DTCs.
This key cycle may be needed when attempting
to communicate with other controllers after a
period of time on a different controller.
Refresh DTCs Button
Tapping the Refresh button initiates a fresh scan
of DTCs from the vehicle.
Share DTCs Button
Tapping the Share button opens the app and
initiates one of two options, share by email or
Bluetooth email concontaining a list of all the
DTCs set.
Menu Button
Tapping the Menu button displays a pop-up link
that takes the user to help content related to
reading DTCs.
Note: an active internet connection will be
required.
Use Metric Units
Selecting Metric Units will switch from English/
Standard Units to Metric Units
Use English/Standard Units
Selecting English/Standard Units will switch
from Metric Units to English/Standard Units.
Take Screen Capture
Selecting Take Screen Capture will save a copy
of the current open screen.
800.MACTOOLS
37