MAC TOOLS MDT 10 Operator's Manual page 109

Mode 5 (Oxygen sensor tests)
Mode 5 views O2 sensor monitor test results.
Mode 5 views O2 sensor monitor test results. Mode 5 displays the average of the O2 sensor monitor test results
measured over a period of time. The parameters of this measurement vary between manufacturers. It may be
necessary to run the vehicle for a period of time to allow the O2 sensors to fully warm up and begin operating.
Note: Mode 5 is not supported on all vehicles.
Mode 6 (Non-continuous monitor tests)
Mode 6 views onboard monitoring test results for noncontinuous monitor systems.
Non-Continuous Monitor Tests (Mode 6) are pass/fail tests, including certain EVAP tests, catalyst, and EGR.
The following information is reported:
• ECU.
• TID (test identification) indicates the system monitor.
• CID (component identification) indicates the component tested and its test value.
• Minimum value, maximum value, and current value for each non-continuous monitor.
• Pass or fail test result.
Each vehicle manufacturer assigns a code number to their system monitors and components. Refer to the
vehicle manufacturers Mode 6 code chart to determine the failure indicated by the TID and CID. If this chart
is not readily available, run an automated system test (AST) from the DTC screen and select Mode 6. See Read
DTCs section for more information regarding steps to complete this action. This may provide a more detailed
description of the Mode 6 test information.
800.MACTOOLS
ss02553
Current
Automated System Test
Report
2007
SUMMARY Oxygen Sensor Tests (Mode 5)
Jeep
DTCs
Description
DATA STREAM SNAPSHOT
Bank 1 Sensor 1
MODE 1
High Sensor Voltage For Switch Time Calculation
FREEZE FRAME
Lean To Rich Sensor Switch Time
MODE 5
Lean To Rich Sensor Threshold Voltage
MODE 6
Low Sensor Voltage For Switch Time Calculation
Maximum Sensor Voltage For Test Cycle
Minimum Sensor Voltage For Test Cycle
Rich To Lean Sensor Switch Time
Rich To Lean Sensor Threshold Voltage
ss02554
Current
Automated System Test
Report
2007
SUMMARY Non-Continuously Monitored Tests
Jeep
(Mode 6)
DTCs
DATA STREAM SNAPSHOT
ECU: ENGINE
MODE 1
TID 1
CID 1
FREEZE FRAME
MODE 5
TID 2
CID 2
MODE 6
TID 3
CID 3
TID 4
TID 1
TID 1
N/A 14080 27283
MIN VALUE MAX
TID 2
TID 2
N/A 42117 18690
MIN VALUE MAX
TID 3
TID 3
N/A 8589 1622
MIN VALUE MAX
TID 4
Min Value Max Units
0.000 0.003 1.275 V
0.000 0.002 1.020 sec
0.000 0.003 1.275 V
0.000 0.003 1.275 V
0.000 0.003 1.275 V
0.000 0.003 1.275 V
0.000 0.002 1.020 sec
0.000 0.003 1.275 V
Passed
N/A
UNITS
Failed
N/A
UNITS
Failed
N/A
UNITS
Failed
109