Table of Contents
Advertisement
Installation Worksheet
Start the Oracle ILOM console mode by typing the following:
4
start /SP/console
Note –
default settings.
Only accounts with Administrator privileges are enabled to configure the SP serial port. See the
Oracle ILOM 3.0 documentation.
Follow the onscreen prompts.
5
Use the information gathered in the
6
system and network information as you are prompted.
The screens that are displayed vary, depending on the method that you chose for assigning
network information to the server (DHCP or static IP address).
After you have entered the system-configuration information, the server completes the boot
process and displays the login prompt.
You can access the Oracle Solaris OS user documentation at:
See Also
For the Solaris 10 OS:
■
For the Solaris 11 OS:
■
▼
(Optional) How to Redirect the Console Output to the
Video Port
Caution –
seriously disrupt the proper functioning of the server or render the server unbootable if you
introduce a problem in the bootenv.rc file.
This procedure assumes you have connected to the server using the SP's IP address. See
Before You Begin
Connect to the Server Using the Server's IP Address" on page
●
Run the eeprom command at the prompt using the following arguments:
/eeprom console=text/
118
Sun Server X2-8 (formerly Sun Fire X4800 M2) Installation Guide • August 2013
If you have changed the default SP serial port settings, make sure you reset them to the
Oracle Solaris 10 8/11 Information Library
Oracle Solaris 11 Information Library
This procedure is intended for advanced users of Oracle Solaris OS only. You can
"Installation Worksheet"on page 114
to help you enter the
117.
"How to
Advertisement
Table of Contents
