Table of Contents
Advertisement
DISK
SD memory can be used, and at least 1GB size is
recommended. Either EXT3 or FAT32 file system can
be used. A disk with either EXT3 or FAT32 file system
can be read in Linux PC. However, only disk with
FAT32 file system can be read in Windows PC
Less than 4Mbps of video bit rate is recommend when
you record and monitor video simultaneously for
frame dropping may happen due to performance
limitation.
Please don't remove SD card on which recording is
going. Files can be damaged..
Disk information
During booting, the system reads status of disk and
initializes it. Once the initialization of a disk is finished,
the status of disk is shown on Record page of web-
based setup.
Refer to the chart for checking the status of disk.
Disk status
Disk error detected
No disk
Searching
Disk information
Mounting and
Recovering Disk...
Disk format needed
Unknown
disk type detected
USB Disk available
Disk removed or
in abnormal state
Description
Error
Disk is not connected to the system.
Checking the status of disk. Refresh
the page and wait until the status is
changed.
Performing recovery process when
disk damage is found. It takes from
seconds to minutes for recovering.
Disk is attached, but the type of the
file system is unknown or damaged.
Available to be used for recording
Disk is detached during operation or
there is damage on the file system. If
it happens while disk is connected, it
is recommended to format the disk.
General
Use record
- Off: Recording function will not be used when "Off"
is selected
- Use Disk: Recording will be enabled and data will be
written to a disk
- Use FTP: Recording will be enabled and data will be
uploaded to an FTP server.
☞ When FTP is activated in the record page by
selecting Use FTP or Use Disk with enabling
Automatically Backup to FTP, FTP upload by event is
automatically disabled.
Select Video: Select video stream to record
Overwrite: When the disk becomes full, the oldest
data are deleted automatically. It is valid only when
Use Record is set to Use Disk.
Max File Size/Max File Length: Max File Size option
is for limiting the size of AVI file. If small file size is set,
files of small size will be generated but numbers of
the files will be increased. Max File Length option is
for limiting the time length of AVI file. If the size of a
file becomes Max File Size or the duration of the
recording reaches Max File Length, a new file is
created.
Automatically Backup to FTP: Data recorded in the
disk can be uploaded to an FTP server automatically
for backup. FTP server is configured on Event page. It
is valid only when Use Record is set to Use Disk.
Erase After Backup: Data are deleted in the disk
automatically after being uploaded to the FTP server.
It is valid only when Automatically Backup to FTP is
used.
Start Time of Backup Data: Specify the time of the
data in the disk from which Backup to FTP Disk is
performed. This time is changed automatically as the
backup to FTP server goes. So it is useful to check
current backup status. It is valid only when
Automatically Backup to FTP is used.
Event Type
Three recording modes are supported: Continuous,
Event, Disconnect. In case of Event recording, event
types can be selected among several events. Selected
event type is used for configuring the schedule table.
Up to 4 event types can be configured and each event
type can be a combination of sensor and motion
event.
Pre-event Time: Specify the duration of recording
Remote Configuration
35
Advertisement
Table of Contents
