Protocol And Baud Rate Settings - LG LW9424 Owner's Manual

12
Installation
The camera ID range is 1~255. Camera ID must not
be 0.
Factory default of Camera ID is 1.
Match the camera ID with Cam ID setting of your DVR
or Controller to control the camera.

Protocol and baud rate settings

ON
Select the appropriate Protocol with DIP switch
combination.
Switch State
P0 (Pin 1) P1 (Pin 2)
OFF OFF
ON OFF
OFF ON
ON ON
OFF OFF
Otherwise
If you want to control using DVR or P/T controller,
their protocol must
be identical to camera. Otherwise, you can not control
the camera.
Adjust the DIP switch after turning off the camera. If
you changed the camera protocol by changing the
DIP switch, the change will be effective after you
reboot the camera.
Factory default of protocol is "LG Multix, 9600 bps".
ON
1 2 3 4
Protocol/Baud rate
P2 (Pin 3)
OFF PELCO-D, 2400 bps
OFF PELCO-D, 9600 bps
OFF PELCO-P, 4800 bps
OFF PELCO-P, 9600 bps
ON LG Multix, 9600bps
Reserved