LG LW9424 Owner's Manual page 25

SNMP is not used by setting 0 value.
SNMP Trap Destination IP: Set the SNMP Trap
Destination IP.
SNMP Trap Destination Port: Set the SNMP Trap
Destination Port. SNMP is not used by setting 0 value.
Simple Network Management Protocol (SNMP) is used by
network management systems to communicate with network
elements. SNMP lets TCP/IP-based network management clients use
a TCP/IP-based internetwork to exchange information about the
configuration and status of nodes. SNMP can also generate trap
messages used to report significant TCP/IP events asynchronously
to interested clients. For example, a router could send a message if
one of its redundant power supplies fails or a printer could send an
SNMP trap when it is out of paper
Multicast
Multicast IP
The Multicast menu is used for configuring the
multicast IP address to which media stream is
delivered when a client such as a CMS or NVR
software is connected in multicast mode. The
multicast IP address selection range is between
224.0.0.0 and 239.255.255.255. The selection can be
used only when media protocol is set to Multicast.
DDNS
Select the DDNS (Dynamic DNS) server to use.
Bitrate control
When there are more than one client connected to
the camera, due to bandwidth difference among the
clients some of them do not have enough bandwidth
to receive encoded stream completely. In this case, it
is possible to select the way to stream video to clients
as following.
Frame Drop Mode: Encoding is performed strictly
according to video settings. When a client is
connected through a network with less bandwidth, it
may not receive all the frames. That is, frames are
dropped on sending module if the network is
bottlenecked.
Suppression Mode: Encoding bitrate and frame rate
are adjusted not to drop any frames when the
network bandwidths to some clients are limited. In this
case, all clients can be affected by the averaged
bitrate and frame rate.
Address Info
Followed network information is displayed (Read only)
IP Address: The Camera own IP address. This
information is useful when the camera's IP mode
is set to DHCP.
Domain Name: In case the camera is registered at
DDNS server, the registered domain name is displayed.
MAC Address: Display the MAC address of the
camera. In case the camera is registered at DDNS
server, the MAC address is used in DDNS registration.
Remote Configuration
25