Table of Contents
Advertisement
14
System Operation
S
y
s
t
e
m
O
p
S
y
s
t
e
m
O
p
Remote Video Monitoring
There are two ways to monitor video when the center
system and LW9424 are connected. In order for a
proper
operation,
accordingly. Please refer to Remote Setting for further
details.
Video Monitoring using Internet Explorer
Open Internet Explorer and enter camera's IP address.
The system will ask for confirmation to install Active-X
control. Once authorized, the Internet Explorer will
start to display video images from camera as shown.
Default ID: admin / PW: admin
Video Selection
Select the Video stream to be viewed: Primary or
Secondary
This camera is capable of dual streaming; primary
streaming and secondary streaming.
Video will be displayed according to the resolution set
on video configuration. If dual streaming ("Use Dual
Encode" Menu in Video page) is not activated,
secondary video is not available
Screen Size
Adjust the Screen size
Screen size is initially adjusted according to the
compression resolution. If you click 50% icon, the
whole screen size will be reduced to half size.
Digital Zoom
e
r
a
t
i
o
n
e
r
a
t
i
o
n
an
IP
address
must
Control the Digital zoom on the screen
be
set
The more the camera zooms in, the smaller the square
of control panel is. Position of the image can be
changed by moving position of the square. Max x5
Digital Zoom is available.
If you press x1, the screen will return to the normal
size. This digital zoom function is operated on a web
browser and different from digital zoom function of a
camera.
PTZ Control Panel (Optical Zoom & Digital zoom
built-in the camera)
Control PTZ and PTZ Control Panel is used for
controlling external PTZ devices when the external PTZ
devices are connected through serial port.
It is possible to make zooming control by Zoom
in/out buttons of PTZ control Panel (In order to use
digital zoom, select Digital zoom ON in the Camera
tab)
Focus Near, Focus Far, Auto Focus, Manual Focus
Adjust the focus of the lens
Select Preset
Set preset position and move to the specific preset
position.
- Goto: Move to the selected preset entry if the preset
entry is set.
- Set: Set the current position to the selected preset
entry.
- Clear: Delete the selected preset entry.
Select List
Run a selected Pattern or Swing or Group.
After selecting an entry in the list, Pattern, Swing or
Group button can be pressed. Then, corresponding
operation is executed for the selected list.
(Please refer to the PTZ tab to set Pattern, Swing and
Advertisement
Table of Contents
