Table of Contents
Advertisement
32
Remote Configuration
PTZ
Circular plate provides panning and tilting functions
combined with speed control. Clicking a mouse on a
position of the circular plate determines the speed of
the control as well as the direction.
Mask
Mask is a function to hide specific regions in the
scene for privacy's reason etc. Mask regions in the
target scene are maintained regardless of a PTZ action.
Max 8 mask regions can be defined.
Select one of the entries in Select Mask Number list.
New: A new mask is created on the center of the
scene. Existing mask with the same number will be
erased.
Search: Control PTZ to view the mask region on the
center of the video area. Nothing happens if
corresponding mask doesn't exist.
Erase: The mask with selected number is erased.
Erase All: All masks are erased.
4 arrow buttons: Adjust the size of the mask.
Notice: Mask area adjusts its position and size
according to PTZ operations. Since there can be a
little latency between PTZ control and adjustment of
mask area, it is useful to configure the mask area a
little large in case the area should be protected strictly.
Note : Size and position of mask areas can be
automatically adjusted by PTZ operation. There may
be time delay. A mask can not be configured at
positions higher than 70 degrees.
Preset
Max 128 preset positions can be defined.
Select Preset Number: Select an entry in the list to
be assigned to current camera position.
Focus Mode: Select the focus mode after preset Goto
is executed.
. Do not change: current focus mode is not changed.
. Focus Auto: auto-focusing is executed after the
preset moved.
. Focus Manual: move to the focus position saved
when preset set.
Event Holding Time: Set the time to stay at the
preset position when the preset moved by event.
If it is set to 0, the camera doesn't return to original
position after moving to the preset position by event.
Edit Label: Assign a label to the preset position. Only
the first 15 preset entries (Preset-1 ~ Preset-15) can
have labels.
Pattern
Pattern is a function that the camera memorizes the
path (mostly curve path) by joystick of controller for
assigned time and revives the path exactly as it
memorized. 4 patterns can be defined and max 760
communication commands can be stored in a pattern.
Select one of the entries in Select Pattern Number
list
Press Set Pattern Start button. Form the pattern by
controlling PTZ. Every path will be saved until pressing
Set Pattern Stop button
Press Set Pattern Stop button to save the pattern
Press Run Pattern button to run the selected pattern
Notice: When the camera memorizes patterns, not the
positions of pan/tilt/zoom but the commands are
stored in the memory. Hence there might be small
differences between the original path visited on
forming the pattern and the revived path on running
the pattern.
Swing
By using swing function, you can make camera to
move between 2 preset positions repeatedly. When
swing function runs, camera moves from the preset
assigned as the 1st point to the preset assigned as
the 2nd point in CW(Clockwise) direction. Then
camera moves from the preset assigned as the 2nd
point to the preset assigned as the 1st point in
CCW(Counterclockwise) direction.
In case the preset assigned as the 1st point is same as
the preset assigned as the 2nd point, camera turns on
its axis by 360 in CW(Clockwise) direction and then it
turns on its axis by 360 in CCW(Counterclockwise)
direction.
.
Check Enable box
Select the Preset for 1st Position and 2nd Position
Enter the Speed (0~255)
Press Save Swing button to save the Swing
Advertisement
Table of Contents
