Commission Modes; Figure 3-3 Panels Available For The Micromaster 430 Inverter; Figure 3-4 Dip Switch - Siemens MICROMASTER 430 Operating Instructions Manual

Issue 10/06
3.2

Commission modes

In the standard version, the MICROMASTER 430 is fitted with the Status Display
Panel (SDP) (see Figure 3-3) with which it is possible to use the inverter with the
pre-assigned factory settings for a large range of applications. If these factory
settings are not suitable, you can adapt them to suit your equipment conditions
using the Basic Operator Panel-2 (BOP-2) (see Figure 3-3). The BOP-2 are
available as options. You can also adjust the factory settings using the PC IBN tool.
This software is available on the CD ROM which comes with the documentation of
the unit.
ATTENTION
MICROMASTER 430 can only be operated with the BOP-2.
It is not possible to use BOP or AOP.
Figure 3-3
For notes on replacing the operator panels please refer to the corresponding
appendix A to this manual.
NOTICE
Adjusting the motor frequency 50/60 Hz: The DIP switch to adjust the motor fre-
quency is located below the I/O board (for removing the I/O board, see appendix C)
The inverter is delivered as follows:
DIP switch 2:
♦ Off position: European
defaults (50 Hz, kW etc.)
♦ On position: North American
defaults (60 Hz, hp etc.)
DIP switch 1:
Not for customer use.
MICROMASTER 430 Operating Instructions
6SE6400-5AE00-0BP0
SDP
Status Display Panel
Panels available for the MICROMASTER 430 Inverter
http://nicontrols.com
BOP-2
Basic Operator Panel
DIP Switch for
motor frequency
Figure 3-4 DIP switch
3 Commissioning
47