Replacing Infolight - Jenn-Air JDB9600AW Technical Education

5.21

Replacing infolight

Infolight
If the Infolight must be exchanged, be examined
damming mat and cable run and adapted if necessary
Squeeze noses carefully together.
Remove Infolight to the door center.
In case of a defect the Infolight is to be renewed completely.
With the installation the cutout of the damming mat and the cable run
are to be examined. If the damming mat still is in the form such as
illustration 1, this 15mm is to be cut out further, sees illustration 2.
This is valid only for fully integrated devices without Piezooperation.
Illustration 1: Cut out damming mat to FD 8810 and devices with Piezooperation
Illustration 2: Cut out damming mat from FD 8811on