Alarm 700059; Specific Turning Alarms; Alarm 700013 - Siemens SINUMERIK 808D Service Manual

Note
Press the following key on the MCP to cancel the alarm after eliminating the faults.
4.2.9

Alarm 700059

Alarm description
The part program cannot be executed without closing the safety door.
PLC information
PLC address: DB1600.DBX7.3
Subroutine: AUX_MCP (SBR 20)
Remedy
Check whether the safety door is closed (if using the safety door control key on
•
the MCP, check whether this key is activated).
Check the interface X102 on the back of the PPU for the following:
•
– Whether the connection of pin 7 is loose/broken
– Whether pin 10 is connected to 0 V properly
Check whether the door-closed limit switch works normally.
•
Note
Press the following key on the MCP to cancel the alarm after eliminating the faults.
4.3

Specific turning alarms

4.3.1

Alarm 700013

Alarm description
The chuck is not clamped. In this case, the operations of cycle start as well as the forward/reverse rotation of the spindle are
not allowed.
PLC information
PLC address: DB1600.DBX1.5
Subroutine: Lock_ unlock _T (SBR 56)
40
Service Manual
01/2017