ADJ Vizi Q Wash7 User Instructions page 17

Vizi Q Wash7
2. Press the LEFT or RIGHT buttons until "Dim Curve" is displayed,
press ENTER.
3. The current dimmer curve setting will now be displayed.
4. Use the LEFT or RIGHT buttons to find your desired dimmer curve
setting.
5. Press ENTER to confirm your selection or press MODE to exit.
Temperature C/F
Temperature C/F - With this function, you can change the tempera-
ture display to show either Celsius or Fahrenheit.
1. Press the MODE button to access the main menu. Press the UP or
DOWN buttons so that "Function" is highlighted, then press ENTER.
2. Press LEFT or RIGHT buttons, until "Temp. C/F" is displayed, and
press ENTER.
3. Either "Celsius" or "Fahrenheit" will be displayed, use the LEFT
or RIGHT buttons to toggle between.
4. Press ENTER to confirm your selection or press MODE to exit.
Init.Effect
Init.Effect - In this menu you are able to check the initial effect posi-
tion.
1. Press the MODE button to access the main menu. Press the UP or
DOWN buttons so that "Function" is highlighted, then press ENTER.
2. Press the UP or DOWN buttons until "Init.Effect" is displayed,
press ENTER.
3. "XXX" will be displayed. "XXX" represents the current effect posi-
tion.
4. Press ENTER or press MODE to exit.
Wireless On/Off and Address:
This function is used to activate WiFly and set the wireless address.
This address must match the address that is set to WiFly TransCeiver
ADJ Products, LLC - www.adj.com - Vizi Q Wash7 Instruction Manual Page 32
System Menu Vizi Q Wash7
or WiFly controller.
1. Plug the fixture in and access the main menu. Press the UP or
DOWN buttons until "Function" is displayed, and press ENTER.
2. Press the LEFT or RIGHT buttons until "Wireless" is displayed.
"XX" represents the current displayed address. Press ENTER to
acess, and use the LEFT or RIGHT buttons to adjust the wireless
channel.
3. When you are finished making your adjustment press ENTER and
press the MODE button to exit this menu.
disp. Set
Chan. Value - This function will allow you to see the DMX value of
each DMX channel that is currently being used at the time.
1. Access the main menu, and press the UP or DOWN buttons so
that "Function" is highlighted, then press ENTER.
2. Press the LEFT or RIGHT buttons until "Chan. Value" is displayed,
and press ENTER.
3. A DMX Channel will be displayed. Example: Pan, Rotation, LED's
etc... Press ENTER when you find the DMX channel that you would
like to check. When you press ENTER the DMX value of that channel
will displayed.
4. Press the MODE button to exit.
Slave Set - This function lets you designate the unit as the slave in a
Master-Slave configuration.
1. Access the main menu, and press the UP or DOWN buttons so
that "Function" is highlighted, then press ENTER.
2. Press the LEFT or RIGHT buttons until "Slave Set" is displayed,
and press ENTER.
3. Either Slave 1, Slave 2, or Slave 3 will be displayed. Use the LEFT
or RIGHT buttons to find your desired setting and press ENTER, or
the press MODE button to exit.
ADJ Products, LLC - www.adj.com - Vizi Q Wash7 Instruction Manual Page 33
System Menu