ADJ Vizi Q Wash7 User Instructions page 14

Vizi Q Wash7
the address that is currently assingned to the unit. Then set
Channel 1's value to "7", Channel 2's value to "7", and Chan-
nel 3's value to "57". Wait 20 seconds and the address should
change on the unit to "57".
2nd EXAMPLE: If you want the address to be 420, you must
first set the address that is currently assingned to the unit. If
you want the set the address to 420, set Channel 1's value to
"7", Channel 2's value to "8", and Channel 3's to "164". (256 +
164 = 420).
No DMX Mode - With this function if the DMX signal is suddenly lost,
the unit will automatically go into 1 of 3 modes.
1. Press the MODE button to access the main menu. Press the UP or
DOWN buttons so that "Function" is highlighted, then press ENTER.
2. Press the LEFT or RIGHT buttons until "Status" is displayed, press
ENTER.
3. Press LEFT or RIGHT buttons, until "No DMX Mode" is displayed,
and press ENTER.
4. Either "Hold" (Last DMX setting), "Blackout", or "Auto" (Auto
Program) will be displayed, use the LEFT or RIGHT buttons to toggle
between.
5. Press ENTER to confirm your selection or press MODE to exit.
Pan Invert - With this function you can reverse the Pan movement.
1. Press the MODE button to access the main menu. Press the UP or
DOWN buttons so that "Function" is highlighted, then press ENTER.
This function is used with DMX mode.
2. Press the LEFT or RIGHT buttons until "Status" is displayed, press
ENTER.
3. Press LEFT or RIGHT buttons, until "Pan Invert" is displayed, and
press ENTER.
4. Either "Off" or "On" will be displayed, use the LEFT or RIGHT but-
tons to toggle between.
ADJ Products, LLC - www.adj.com - Vizi Q Wash7 Instruction Manual Page 26
System Menu Vizi Q Wash7
5. Press ENTER to confirm your selection or press MODE to exit.
Tilt Invert - With this function you can reverse the left head Tilt
movement. This function is used with DMX mode.
1. Press the MODE button to access the main menu. Press the UP or
DOWN buttons so that "Function" is highlighted, then press ENTER.
2. Press the LEFT or RIGHT buttons until "Status" is displayed, press
ENTER.
3. Press LEFT or RIGHT buttons, until "Tilt Invert" is displayed, and
press ENTER.
4. Either "Off" or "On" will be displayed, use the LEFT or RIGHT but-
tons to toggle between.
5. Press ENTER to confirm your selection or press MODE to exit.
Pan Degree - With this function you can change the pan degree from
630 to 540. This function is used with DMX mode.
1. Press the MODE button to access the main menu. Press the UP or
DOWN buttons so that "Function" is highlighted, then press ENTER.
2. Press the LEFT or RIGHT buttons until "Status" is displayed, press
ENTER.
3. Press LEFT or RIGHT buttons, until "Pan Degree" is displayed,
and press ENTER.
4. Either "540" or "630" will be displayed, use the LEFT or RIGHT
buttons to toggle between.
5. Press ENTER to confirm your selection or press MODE to exit.
Feedback - With this function, you have the pan and tilt postion
feedback while out of step or not feedback while out of step.
1. Press the MODE button to access the main menu. Press the UP or
DOWN buttons so that "Function" is highlighted, then press ENTER.
2. Press the LEFT or RIGHT buttons until "Status" is displayed, press
ENTER.
ADJ Products, LLC - www.adj.com - Vizi Q Wash7 Instruction Manual Page 27
System Menu