D-Link DSL-2740E User Manual page 9

Hide thumbs Also See for DSL-2740E:
Table of Contents

Advertisement

LED
Color
WPS
Green
DSL
Green
Internet
Red
Rear Panel
The following table describes the interface of the device.
Interface/Button
RJ-11 interface for connecting the host to the telephone
DSL
jack on the wall or the MODEM interface of the splitter
through a telephone line.
DSL-2740E User Manual
Status
and the client, the LED would
light steady for 5 seconds.
Blinking
WPS is successfully triggered.
Device is ready for new WPS
Off
setup.
Off
No signal is being detected.
The device is handshaking with
Blinking
the physical layer of the office
end.
A connection is set up with the
On
physical layer of the office end.
The device is under the Bridge
Off
mode or powered off.
A connection is set up and no
On
traffic is detected.
The authentication of the PPP
dial-up is failed or MER is failed
On
to obtain the correct IP
address.
Figure 2 Rear panel
Description
3
Description

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents