D-Link DSL-2740E User Manual page 34

DSL-2740E User Manual
The following table describes the parameters of this page.
Field
WAN Physical
Type
cable.
Default Route You can select Auto or Specified.
Selection
The virtual path between two points in an ATM
VPI
network, ranging from 0 to 255.
The virtual channel between two points in an ATM
VCI network, ranging from 32 to 65535 (1 to 31 are
reserved for known protocols)
Encapsulation You can choose LLC and VC-Mux.
You can choose 1483 Bridged, 1483 MER, PPPoE,
Channel Mode
PPPoA, 1483 Routed or IPoA.
Select it to enable Network Address Port Translation
(NAPT) function. If you do not select it and you want
Enable NAPT to access the Internet normally, you must add a
route on the uplink equipment. Otherwise, the
access to the Internet fails. Normally, it is enabled.
You can enable or disable Internet Group
Enable IGMP
Management Protocol (IGMP) function.
You can select Disable or Enable. If enabled, you
802.1q
need to enter the VLAN ID.
VLAN ID The value ranges from 1 to 4095.
When any channel mode except 1483 Bridged is
IP Protocol selected, select an IP protocol from IPv4/IPv6, IPv4
and IPv6.
PPP Settings
Enter the correct user name for PPP dial-up, which
User Name
is provided by your ISP.
Enter the correct password for PPP dial-up, which is
Password
provided by your ISP.
You can choose Continuous, Connect on
Type
Demand or Manual.
Description
ADSL WAN: ADSL uplink via telephone cable.
Ethernet WAN: Ethernet uplink via Ethernet
28