Table of Contents
Advertisement
DSL-2740E User Manual
The following table describes the parameters in this page.
Field
Enter the IP address of LAN interface. It is recommended to
IP
use an address from a block reserved for private use. This
Address
address block is 192.168.1.1- 192.168.1.254.
Subnet
Enter the subnet mask of LAN interface. The range of subnet
Mask
mask is from 255.255.0.0-255.255.255.254.
Secondary
Select it to enable the secondary LAN IP address. The two LAN
IP
IP addresses must be in different subnets.
LAN Port
You may choose the LAN interface you want to configure.
Link
You may select one mode from the drop-down list:
Speed/
100Mbps/FullDuplex, 100Mbps/Half Duplex,
Duplex
10Mbps/FullDuplex, 10Mbps/Half Duplex and Auto
Mode
Negotiation.
MAC
It is the access control based on MAC address. Select it, and
Address
the host whose MAC address is listed in the Current Allowed
Control
MAC Address Table can access the modem.
Enter MAC address, and then click this button to add a new
Add
MAC address.
3.2.2.2 LAN IPv6 Interface
Choose Setup > Local Network > LAN IPv6 Interface. The LAN IPv6 Setting
page shown in the following figure appears. You may set LAN RA server work
mode and LAN DHCPv6 server work mode.
Description
18
Hide quick links:
Advertisement
Table of Contents
