Anti Condensation Switch - Napoleon BHD4P Installation And Operating Instructions Manual

46
8.3

ANTI CONDENSATION SWITCH

NOTE: End safety screen must be removed before accessing the anti-condensation switch, see "END
EN
SAFETY SCREEN REMOVAL / INSTALLATION" section for detailed removal instructions.
This appliance has the ability to switch from an electronic intermittent pilot ignition (IPI) to a standing pilot
(ACS) for cold climates. The heat generated by the standing pilot will improve the start up operation on
colder climate days. Therefore we recommend switching to the standing pilot on those colder days. The anti
condensation switch (standing pilot) is located in the control compartment. Using your finger, flip the switch
up for standing pilot, or down for intermittent pilot ignition.
PANEL COVER
INSTALLER NOTE: Some jurisdictions
may prohibit the use of a standing
pilot. In these jurisdictions the
anti condensation switch shall be
CONTROL
disconnected to comply with local
codes. To disconnect locate the white
PANEL COVER
connector at the end of the
white and blue wires of the
ACS switch and disconnect.
W415-1285 / F / 12.21.16