Battery Back-Up Installation - Napoleon BHD4P Installation And Operating Instructions Manual

Natural gas. propane fireplace
Table of Contents

Advertisement

Available languages

Available languages

44
7.3

BATTERY BACK-UP INSTALLATION

NOTE: In the event of a power failure your appliance can be operated using the battery back-up supplied.
EN
A. Remove the safety screen and door, refer to the "MAIN SAFETY SCREEN REMOVAL/INSTALLATION" and
"MAIN DOOR REMOVAL/INSTALLATION" sections for detailed removal instructions.
B. Remove the panel cover using the two finger holes, then remove the control panel cover by lifting it up
and off of the four shoulder screws. This will allow you to easily access the battery housing.
C. Remove your battery housing to install the batteries, this will be located in the control compartment,
as shown below.
D. Install the four "AA" batteries, ensure the positive and negative ends correspond with those identified
on the battery housing.
E. Place the battery housing back into position or let it rest on the hearth, for the duration of the power failure.
NOTE: Once the power has been restored, remove the batteries from the battery housing. The system
will drain the batteries if they are left in the battery housing. It is recommended that you change the
battery at the start of the heating season.
PANEL COVER
CONTROL
PANEL COVER
W415-1285 / F / 12.21.16
BATTERY
HOUSING

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Bhd4nBhd4pg

Table of Contents