Hearth Pad Installation; Log Placement - Napoleon BHD4P Installation And Operating Instructions Manual

38
6.6

HEARTH PAD INSTALLATION

NOTE: The individual hearth pads can be easily identified by the
numbers cast on the underside of each pad.
EN
NOTE: The pilot is located on the right end in these instructions.
Remove the main safety screen and door from the appliance, see
A.
"MAIN SAFETY SCREEN REMOVAL/INSTALLATION" and "MAIN
DOOR REMOVAL/INSTALLATION" sections for detailed removal
instructions. HINT: For ease of installation, remove both main
doors.
Place the #3 hearth pad on the pilot side of the burner, as shown
B.
in Figure B.
Place the #1A hearth pad on the right side and the #1 hearth pad
C.
on the left side of appliance, as shown in Figure C.
Place the two #2 hearth pads on the right and left sides, as
D.
shown in Figure D.
E. Place the #4 hearth pad on the left end, as shown in Figure E.
6.7

LOG PLACEMENT

FAILURE TO POSITION THE LOGS IN ACCORDANCE WITH THESE DIAGRAMS OR FAILURE TO USE
ONLY LOGS SPECIFICALLY APPROVED WITH THIS APPLIANCE MAY RESULT IN PROPERTY
LOGS MUST BE PLACED IN THEIR EXACT LOCATION IN THE APPLIANCE. DO NOT MODIFY THE
PROPER LOG POSITIONS, SINCE APPLIANCE MAY NOT FUNCTION PROPERLY AND DELAYED
NOTE: The individual logs can be easily identified by the numbers cast on the underside of each log.
Phazer logs and glowing embers, exclusive to Wolf Steel Ltd., provide a unique and realistic glowing effect
TM
that is different in every installation. During the initial use of the appliance, log colours may vary. During the
initial use of the appliance, the colours will become more uniform as colour pigments burn in during the heat
activated curing process.
Blocked burner ports can cause an incorrect flame pattern.
NOTE: The pilot is located on the right end in these instructions.
1. Remove the main safety screens and doors, see "MAIN SAFETY
SCREEN REMOVAL/INSTALLATION" and "MAIN DOOR
REMOVAL/INSTALLATION" sections for removal instructions.
2. Place a pin into the bottom of log #1 lining it up with the hole in
the hearth pad. Then place onto the screw and spacer located
in the corner of the burner, on the right side. Place a pin into the
center of log #1, as shown in Figure 1.
3. Place log #2 onto the pin located in the log #1, it should rest
in the middle of the left side hearth pad as shown in Figure 2.
Place one pin into the middle of log #2, as shown in Figure 2.
W415-1285 / F / 12.21.16
DAMAGE OR PERSONAL INJURY.
IGNITION MAY OCCUR.
THE LOGS ARE FRAGILE AND SHOULD BE HANDLED WITH CARE.
WARNING
!
B
C
D
E
76.1A
PIN
PIN
PIN
Fig. 1
Fig. 2
Fig. 3