Table of Contents
Advertisement
To remove the component:
Power down the server (on page 26).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Do one of the following:
3.
Extend the server from the rack (on page 27).
o
Remove the server from the rack (on page 29).
o
Remove the access panel
4.
Remove the air baffle
5.
Open the DIMM slot latches.
6.
Remove the DIMM.
7.
To replace the component, reverse the removal procedure.
Processor blank
WARNING:
internal system components to cool before touching them.
CAUTION:
precautions before beginning any installation, removal, or replacement procedure. Improper
grounding can cause electrostatic discharge.
CAUTION:
all bays are populated with either a component or a blank.
To remove the component:
Power down the server (on page 26).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
("Access
panel" on page 34).
("Air
baffle" on page 35).
To reduce the risk of personal injury from hot surfaces, allow the drives and the
To prevent damage to electrical components, take the appropriate anti-static
To prevent improper cooling and thermal damage, do not operate the server unless
Removal and replacement procedures 47
Advertisement
Table of Contents
