Flexiblelom Riser Board - HP ProLiant DL80 Gen9 Maintenance And Service Manual

Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Do one of the following:
3.
Extend the server from the rack (on page 27).
o
Remove the server from the rack (on page 29).
o
Remove the access panel
4.
Remove the primary PCI riser cage
5.
Remove any existing expansion board from the riser board
6.
Remove the PCIe riser board.
7.
To replace the component, reverse the removal procedure.

FlexibleLOM riser board

WARNING:
internal system components to cool before touching them.
CAUTION:
precautions before beginning any installation, removal, or replacement procedure. Improper
grounding can cause electrostatic discharge.
To remove the component:
Power down the server (on page 26).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Do one of the following:
3.
Extend the server from the rack (on page 27).
o
Remove the server from the rack (on page 29).
o
Remove the access panel
4.
Remove any existing expansion board from the riser board
5.
Remove the FlexibleLOM riser cage
6.
("Access panel" on page 34).
("Remove the PCI riser
To reduce the risk of personal injury from hot surfaces, allow the drives and the
To prevent damage to electrical components, take the appropriate anti-static
("Access panel" on page 34).
("Remove the PCI riser
cages" on page 30).
("Expansion board" on page 54).
("Expansion board" on page 54).
cages" on page 30).
Removal and replacement procedures 61