Table of Contents
Advertisement
CAUTION:
all bays are populated with either a component or a blank.
To remove the component:
Power down the server (on page 26).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
If installed, remove the security bezel
3.
Remove the drive carrier.
4.
To replace the component, slide the component into the bay until it clicks.
Non-hot-plug drive
CAUTION:
all bays are populated with either a component or a blank.
To remove the component:
Back up all server data on the drive.
1.
Power down the server (on page 26).
2.
Remove all power:
3.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
If installed, remove the security bezel
4.
To prevent improper cooling and thermal damage, do not operate the server unless
("Remove the security bezel
To prevent improper cooling and thermal damage, do not operate the server unless
("Remove the security bezel
(optional)" on page 26).
(optional)" on page 26).
Removal and replacement procedures 32
Advertisement
Table of Contents
