HP ProLiant DL80 Gen9 Maintenance And Service Manual page 102

Item LED Status
Locate Solid blue
1
Flashing blue
Activity ring Rotating green
2
Off
Do not remove Solid white
3
Off
Drive status Solid green
4
Flashing green
Flashing
amber/green
Flashing amber
Solid amber
Off
The blue Locate LED is behind the release lever and is visible when illuminated.
IMPORTANT: The HP Dynamic Smart Array B140i Controller is only available in UEFI Boot Mode.
It cannot be enabled in Legacy BIOS Boot Mode. If the B140i controller is disabled, drives
connected to the system board Mini-SAS connectors operate in AHCI or Legacy mode. Under this
condition:
The drives cannot be a part of a hardware RAID or a logical drive.
•
The Locate, Drive status, and Do not remove LEDs of the affected drives are disabled.
•
Use BIOS/Platform Configuration (RBSU) in the UEFI System Utilities
page 85) to enable or disable the B140i controller (System Configuration → BIOS/Platform
Configuration (RBSU) → System Options → SATA Controller Options → Embedded SATA
Configuration).
Definition
The drive is being identified by a host application.
The drive carrier firmware is being updated or requires an update.
Drive activity
No drive activity
Do not remove the drive. Removing the drive causes one or more of
the logical drives to fail.
Removing the drive does not cause a logical drive to fail.
The drive is a member of one or more logical drives.
The drive is rebuilding or performing a RAID migration, strip size
migration, capacity expansion, or logical drive extension, or is
erasing.
The drive is a member of one or more logical drives and predicts
the drive will fail.
The drive is not configured and predicts the drive will fail.
The drive has failed.
The drive is not configured by a RAID controller.
("HP UEFI System Utilities" on
Component identification 102