Table of Contents
Advertisement
Remove the power input module.
5.
To replace the component, reverse the removal procedure.
RPS backplane
WARNING:
internal system components to cool before touching them.
CAUTION:
precautions before beginning any installation, removal, or replacement procedure. Improper
grounding can cause electrostatic discharge.
To remove the component:
Power down the server (on page 26).
1.
Access the product rear panel (on page 29).
2.
Remove all power:
3.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Remove all installed power input modules
4.
Remove the server from the rack (on page 29).
5.
Place the server on a sturdy, level surface.
6.
Remove the air baffle
7.
If the primary PCI riser cage is installed, do the following:
8.
Remove the primary PCI riser cage
a.
To reduce the risk of personal injury from hot surfaces, allow the drives and the
To prevent damage to electrical components, take the appropriate anti-static
("Air
baffle" on page 35).
("Remove the PCI riser
("Hot-plug power input
module" on page 78).
cages" on page 30).
Removal and replacement procedures 79
Advertisement
Table of Contents
