Table of Contents
Advertisement
General precautions and safety guidelines
Required tools
The following items are required for some replacement procedures:
•
T-8 Torx screwdriver
•
T-10 Torx screwdriver
•
T-15 Torx screwdriver
•
Phillips screwdriver
Component replacement guidelines
CAUTION:
Removing a component significantly changes the air flow within the enclosure. Components must be
installed for the enclosure to cool properly. If a component fails, leave it in place in the enclosure until a
new component is available to install.
Use the following guidelines when replacing a component in the HPE StoreOnce System or the HPE
StoreOnce 5100 System Capacity Upgrade enclosure.
•
Before replacing a component, verify its status to ensure that it needs replacement. To verify component
status, check the status LEDs, event logs, product-specific logs, and management utilities for component
health and location information.
•
Parts can be damaged by electrostatic discharge. Keep parts in electrostatic containers until needed and
ensure you are properly grounded when touching static-sensitive components.
•
HPE recommends waiting until periods of low storage system activity to replace a component.
•
When replacing components at the rear of the rack, cabling might obstruct access to the component.
Carefully move any cables out of the way to avoid loosening any connections. In particular, avoid cable
damage that might be caused by:
◦
Kinking or bending.
◦
Disconnecting cables without capping. If uncapped, cable performance might be impaired by contact
with dust, metal, or other surfaces.
◦
Placing removed cables on the floor or other surfaces, where they might be walked on or otherwise
compressed.
Safety precautions
Retain and follow all product safety and operating instructions. Always refer to the documentation (printed or
electronic) supplied with your product. If there is a conflict between this document and the product
documentation, the product documentation takes precedence. To reduce the risk of bodily injury, electric
shock, fire, and damage to the equipment, observe all warnings on the product and in the operating
instructions.
General precautions
CAUTION:
The installation and maintenance of products must be carried out by qualified personnel.
General precautions and safety guidelines
19
Hide quick links:
Advertisement
Table of Contents
