Indicators And Switches; Rear I/O Panel Indicators - Cobalt Digital Inc 9223 Product Manual

Indicators and Switches

The 9223 card and its rear module is intended for installation only in 20-slot openGear
such as the 20-slot DFR-8321 frame or the Cobalt 8321 frame. Prior to installing the card, first
install the corresponding rear panel I/O module.

Rear I/O Panel Indicators

The 9223 rear I/O panel is depicted below. It includes two software-configurable
Composite/SDI video inputs on standard BNC connectors, two ASI output ports on standard
BNC connectors, four analog audio inputs on standard RCA connectors or 3-pin balanced
terminal blocks (where available), and two 100/1000 Mb/s Ethernet ports on standard RJ-45
connectors.
Note: For HW version 4 or greater, this product is available with unbalanced or balanced analog
audio inputs (depending on rear I/O module used). Balanced analog audio in is not available on
earlier HW versions.
Each of the video inputs has a green indicator LED, with the following states:
• LED off: no video signal detected, or input not configured.
• LED flashing: video input locked to the video signal.
o LED flashing about once per second: input video is SD.
o LED flashing about twice per second: input video is HD-SDI.
o LED flashing about 4 times per second: input video is 3G-SDI (1080p60).
Each of the ASI output ports has a green indicator LED, with the following states:
• LED off: ASI output port is disabled.
• LED flashing: ASI output port is configured and enabled.
Each of the Gigabit Ethernet ports has two indicator LEDs, with the following states:
• Green LED:
o Off: No link
o On: Link
• Yellow LED:
o Off: No activity (transmit and/or receive)
o Flashing: Port is currently transmitting and/or receiving
10
®
frames
9223-OM (V2.5.0)