SCTE 104 Ad Insertion Triggers
If the input signal is SDI, the 9223 is capable of extracting SCTE 104 triggers from the VANC
(inserted as per SMPTE 2010) and converting them to SCTE 35 triggers in the output transport
stream:
• Enable SCTE 104/35: Check this box to enable SCTE 104 extraction. Note that this
control is only displayed if the input signal is SDI or if the encoder is in auto-detect video
mode.
Advanced Tab – Audio Parameters
The Audio Parameters are divided into three subgroups, some of which vary (and may not be
present) according to the selections made in the Encoder Basic Configuration Tab. A sample of
the Audio Parameters section is depicted below.
Analog Audio Parameters
These parameters are only displayed if Audio Source in Basic Tab – Audio Configuration is set
to Analog Audio. The parameters are:
Analog Audio
Parameters
A/V Sync Adjustment
PMT Information
Audio Encoder
Specific Configuration
41
9223-OM (V2.5.0)