Verifying Your Configuration - Cisco ASR 5000 Series Administration Manual

▀ Verifying Your Configuration

Verifying Your Configuration
This section explains how to display and review the configurations after saving them in a .cfg file as described in Saving
Your Configuration chapter of this guide and also to retrieve errors and warnings within an active configuration for a
service.
I
platforms.
These instructions are used to verify the Subscriber Session Trace configuration.
Step 1 Verify that your subscriber session support is configured properly by entering the following command in Exec Mode:
show session trace statistics
The output of this command displays the statistics of the session trace instance.
Num current trace sessions: 5
Total trace sessions activated: 15
Total Number of trace session activation failures: 2
Total Number of trace recording sessions triggered: 15
Total Number of messages traced: 123
Number of current TCE connections: 2
Total number of TCE connections: 3
Total number of files uploaded to all TCEs: 34
Step 2
View the session trace references active for various network elements in an EPC network by entering the following
command in Exec Mode:
show session trace trace-summary
The output of this command displays the summary of trace references for all network elements:
MME
Trace Reference: 310012012345
Trace Reference: 310012012346
SGW
Trace Reference: 310012012345
▄ Cisco ASR 5000 Series Mobility Management Entity Administration Guide
106
:
MPORTANT
All commands listed here are under Exec mode. Not all commands are available on all
Configuring Subscriber Session Tracing
OL-22987-01