Verifying Egtp Service Configuration - Cisco ASR 5000 Series Administration Manual

▀ eGTP Service Configuration

Verifying eGTP Service Configuration

Step 1
Verify that your eGTP services and S11 interface were created and configured properly by entering the following
command in Exec Mode:
show egtp-service name <egtp_svc_name>
The output of this command given below is a concise listing of eGTP service parameter settings as shown in the sample
output displayed. In this example, an eGTP service called egtp_svc was configured and you can see some parameters
configured as default.
Service name
Service-Id
Context
Interface Type
Status
Restart Counter
GTPC Retransmission Timeout
GTPC Maximum Request Retransmissions
GTPC Echo
GTPC Echo Interval
GTPU Retransmission Timeout
GTPU Maximum Request Retransmissions
GTPU Echo
GTP-C Bind Address
Step 2 Verify configuration for errors by entering the following command in Exec Mode:
show configuration-errors section egtp-service
The output of this command displays the errors, if any, in eGTP service configuration.
▄ Cisco ASR 5000 Series Mobility Management Entity Administration Guide
72
MME Service Configuration Procedures
: egtp_svc
: 2
: egtp_mme
: mme
: STARTED
: 8
: 5
: 4
: Enabled
: 60
: 5
: 4
: Disbaled
: 192.20.20.2
OL-22987-01