Saving The Configuration On The Chassis - Cisco ASR 5000 Series Administration Manual

Verifying and Saving Your Configuration

Saving the Configuration on the Chassis

These instructions assume that you are at the root prompt for the Exec mode:
[local]host_name#
To save your current configuration, enter the following command:
save configuration url [-redundant] [-noconfirm] [showsecrets] [verbose]
Keyword/Variable Description
Specifies the path and name to which the configuration file is to be stored. url may refer to a local or a
url
remote file. url must be entered using one of the following formats:
/flash corresponds to the CompactFlash on the SPC/SMC.
/pcmcia1 corresponds to PCMCIA slot 1.
/pcmcia2 corresponds to PCMCIA slot 2.
ipaddress is the IP address of the network server.
host_name is the network server‟s hostname.
port# is the network server‟s logical port number. Defaults are:
Note: host_name can only be used if the networkconfig parameter is configured for DHCP and the
DHCP server returns a valid nameserv er.dx
username is the username required to gain access to the server if necessary.
password is the password for the specified username if required.
/directory specifies the directory where the file is located if one exists.
/file_name specifies the name of the configuration file to be saved.
Note: Configuration files should be named with a .cfg extension.
-redundant Optional: This keyword directs the system to save the CLI configuration file to the local device, defined by the
url variable, and then automatically copy that same file to the like device on the Standby SPC/SMC, if
available.
Note: This keyword will only work for like local devices that are located on both the active and standby
SPCs/SMCs. For example, if you save the file to the /pcmcia1 device on the active SPC/SMC, that same type
of device (a PC-Card in Slot 1 of the standby SPC/SMC) must be available. Otherwise, a failure message is
displayed.
Note: If saving the file to an external network (non-local) device, the system disregards this keyword.
OL-22987-01
{ /flash | /pcmcia1 | /pcmcia2 } [ /dir ] /file_name
file:/{ /flash | /pcmcia1 | /pcmcia2 } [ /dir ] /file_name
tftp://{ ipaddress | host_name [ :port# ] } [ /directory ] /file_name
ftp://[ username [ :pwd ] @ ] { ipaddress | host_name } [ :port# ] [ /directory ]
/file_name
sftp://[ username [ :pwd ] @ ] { ipaddress | host_name } [ :port# ] [ /directory ]
/file_name
tftp: 69 - data
ftp: 20 - data, 21 - control
sftp: 115 - data
Cisco ASR 5000 Series Mobility Management Entity Administration Guide ▄
Saving the Configuration on the Chassis ▀
85