Egtp Service Configuration; Creation Of Egtp Service And Other Parameter Configuration - Cisco ASR 5000 Series Administration Manual

MME Service Configuration Procedures

eGTP Service Configuration

This section provides instructions for configuring eGTP Service to add S11 interface to connect with S-GW with an
MME service.This section provides the minimum instruction set for configuring a GTPP accounting support in a MME
service. Commands that configure additional GTPP accounting properties are provided in the Command Line Interface
Reference.
These instructions assume that you have already configured the system level configuration as described in System
Administration Guide and MME service as described in MME Service Configuration section of this chapter.
Step 1
Create an eGTP service by applying the example configuration in the Creation of eGTP Service and Other Parameter
Configuration section.
Step 2
Verify your eGTP service and S11 interface configuration by following the steps in the section.
Step 3 Save your configuration as described in the Verifying and Saving Your Configuration chapter.

Creation of eGTP Service and Other Parameter Configuration

Use the following configuration example to create the eGTP service and other parameters for S11 interface in the eGTP
service:
configure
context <egtp_ctxt_name>
subscriber default
egtp-service <egtp_service_name>
interface-type interface-mme
gtpc bind address <mme_ip_address>
gtpc max-retransmission <retries>
end
Notes:
A maximum of 256 services (regardless of type) can be configured per system.
<egtp_ctxt_name> is name of the destination context in which eGTP service is to be configured for S11
interface functionality with S-GW.
<mme_ip_address> is the local IP address of this MME service and should not conflict with any other
service.
OL-22987-01
Cisco ASR 5000 Series Mobility Management Entity Administration Guide ▄
eGTP Service Configuration ▀
71