Epson QX-10 Technical Manual page 50

2.5.10 Eject lock lever set
Disassembly procedure
Notes on disassembly
1) Remove the main board set. (Refer to 2.5.1)
2) Remove the sub-frame unit. (Refer to 2.5.3)
3) Remove the front panel. (Refer to 2.5.4)
4) Remove the disk guide (L) unit. (Refer to 2.5.5)
5) Remove the ejector spring.
6) Loosen and remove the E stopper ring of the disk
drive pulley side of the eject lock lever.
RE: ElWJ - 2.3 x 1
Resassembly procedure Notes on resassembly
1) Set the eject lock lever set in the main unit. Insert
•
Check the eject lock lever spring is attached to the
the eject lock lever shaft from the disk guilde (L) eject lock lever set.
unit and fix it with the E stopper ring.
2) Hook the eject spring between the ejector and
main unit.
3) Mount the disk guide (L) unit (Refer to 2.5.5)
4) Mount the front panel (Refer to 2.5.4)
5) Mount the sub-frame unit. (Refer 10 2.5.3)
6) Mount the main board set. (Refer to 2.5.1 )
2-32